How to use Snap in AutoCAD mobile ?

Quick Tip: While in a drawing, hover your finger over a location until a magnifying glass appears, allowing you to set snap points. Repeat to mark snap point destinations.

  1. Touch your finger to the screen and hold there until a magnifying glass appears.

  2. Slide your finger on the screen to identify the location to snap.

  3. Let go when you reach the point you wish to snap to.


Advanced object snap capabilities are offered in the following modes: Endpoint, Intersection, Midpoint, Quadrant, Center, Perpendicular and Extension. To change the snap mode:

  1. Enter the Drawing Settings in the upper right hand side of the screen.

  2. Select the “Object Snap Modes” option.

  3. Select your desired snap mode from the menu.

Additional Information:
  • Should you wish to disable Object Snap, Object Snap Tracking, or Ortho Polar Snap, simply toggle off the button under Drawing Settings.

  • To learn more about Snap in the mobile app, watch this video:​
  • The Snap function is available on both the web and the mobile versions of AutoCAD mobile.
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found